Network Device Installation and User's Guide

Alarms
9/24/01 3-5
Access Bank II - SNMP purchase.
• Control Panel T1 test switches and status LEDs
• Rear panel voice channel option switches, test switches, and status LEDs
• Embedded SNMP agent for performance monitoring and configuration of T1, V.35, and
RS-232 data ports
3.14 Alarms
• Alarm dial-out notification over external modem attached to RS-232 Management port
• External alarm contact for visible/audible alarms using pair 25 of RJ-21X standard tele-
phony connector on Control Panel
• Control Panel Alarm Cut-Off (ACO) Switch
3.15 Control Panel I/O Connectors
• T1 Span 1 and Span 2: Standard RJ-48C 8-pin jacks
• V.35 DCE Data Port: 26-pin D-type subminiature V.35 connector (female)
• Management Interfaces:
• Management: Primary logical RS-232 port for connection to external Hayes-compat-
ible modem or to IBM-PC (or compatible) with MS Windows Hyperterm (or com-
patible), and MS Windows-based Remote Monitor software program installed
• Data: Secondary logical RS-232 data port
• Connector: 26-pin D-type subminiature EIA/TIA RS-232 connector (female)
• Adapter Cable: Dual RS-232 Management Cable for simultaneous connection to
Data and Management RS-232 interface lead
• SNMP RJ-45 jack for 10Base-T Ethernet TCP/IP connection.
• Tip & Ring Interface:Standard 25-pair RJ-21X Telephony Connector (female)
3.16 Standards Compliance
• ANSI/TIA T1.403-1995 One-second Performance Report Messages (PRMs)
• ANSI/TIA 464-A-89 PBX Switching Equipment for Voice Band Applications
• AT&T 54016 Maintenance Messages on the 4 Kbps ESF Facility Data Link (FDL)
• AT&T 62411 Enhanced Stratum 4 Timing Requirements for T1 CPE
• AT&T 62411 Standard T1 Pulse Mask Characteristics
• Bellcore TR-TSY-000057 for Digital Loop Carrier Systems