User's Manual

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 15-17
Configuration - L2TPC Mode
no ip ospf transmit-delay
Use the L2TPC no ip ospf transmit-delay command to restore the default value of 1 second. To
define the estimated time to transmit a link state update packet on the interface, see ip ospf transmit-
delay command on page 15-9.
Syntax: (config-l2tpc-{n})# no ip ospf transmit-delay
Example: (config-l2tpc-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip primary-dns
Use the L2TPC no primary-dns command to disable the primary DNS. To set the DNS primary
IP address, see ip primary-dns command on page 15-10.
Syntax: (config-l2tpc-{n})# no ip primary-dns
Example: (config-l2tpc-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the L2TPC no ip rip command to disable RIP on this interface. To enable RIP, see ip rip
command on page 15-10.
Syntax: (config-l2tpc-{n})# no ip rip
Example: (config-l2tpc-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip route
Use the L2TPC no ip route command remove an IP route. To add a route, see ip route command
on page 15-11.
Syntax: (config-l2tpc-{n})# no ip route dest-ip-addr gateway
Example: (config-l2tpc-1)# no ip route 192.168.100.200 192.168.100.254
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
dest-ip-addr Enter destination IP address to remove.
gateway Enter gateway IP address to remove.