User's Manual

24-12 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Trunk Mode
registration
The registration command enables the user to Add, Edit, Remove, Enable, Disable PBX line number
behind a voice trunk that will register to the SIP proxy.
registration enable
Use the Voice Port Trunk registration enable command to enable the Voice Port registration
feature. To disable Voice Port registration, see no registration enable command on page 24-9.
Syntax: (config-vport-trk-{n})# registration enable
Example: (config-vport-trk-1)# registration enable
Supported Platforms:
Adit 3500, MSR
registration line authentication
Use the Voice Port Trunk registration line authentication command to configure the username to
authenticate.
Syntax: (config-vport-trk-{n})# registration line value line-numbers
value authentication {phone-number|username username} password
password
Example: (config-vport-trk-1)# registration line 1 line-numbers 3
authentication phone-number password hello
Supported Platforms:
Adit 3500, MSR
Field Definition
line value Enter the PBX line number to configure. Range is 1 - 300.
line-numbers value Define the number of lines in this block that are going to be registered.
Starting from the first-phone-number, increased by 1 each.
phone-number Set the phone number to authenticate.
username username Set the user name to authenticate.
password Enter a password for the authentication.