User Guide

23-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port FXS Mode
no commands
no comfort-noise
Use the Voice Port FXS no comfort-noise command to disable comfort noise. To enable remote
access, see comfort-noise command on page 23-2.
Syntax: (config-vport-fxs-{n})# no comfort-noise
Example: (config-vport-fxs-1)# no comfort-noise
Supported Platforms:
Adit 3104, Adit 3500, MSR
no echo-cancel
Use the Voice Port FXS no echo-cancel command disable echo cancellation on this port. To enable
echo cancellation, see echo-cancel command on page 23-4.
Syntax: (config-vport-fxs-{n})# no echo-cancel
Example: (config-vport-fxs-1)# no echo-cancel
Supported Platforms:
Adit 3104, Adit 3500, MSR
no per-line-logging
Use the Voice Port FXS no per-line-logging command disable the logging per line feature. To
enable logging, see per-line-logging command on page 23-7.
Syntax: (config-vport-fxs-{n})# no per-line-logging
Example: (config-vport-fxs-1)# no per-line-logging
Supported Platforms:
Adit 3104, Adit 3500, MSR
no shutdown
Use the Voice Port FXS no shutdown command to set this voice port up (In-Service). To set this
port down (Out-of-Service), see shutdown command on page 23-7.
Syntax: (config-vport-fxs-{n})# no shutdown
Example: (config-vport-fxs-1)# no shutdown
Supported Platforms:
Adit 3104, Adit 3500, MSR