Adit 3500 Quick Start Guide

Adit 3500 - Release 1.6 27

Quick Start Guide

Basic Configuration

The following configuration is divided into logical sections, where each section configures an additional

function. The first must be configured before the second and so forth, however, you may stop at any

section and not add the following feature.

NOTE: The order in which commands are entered can affect the successful provisioning of

the Adit 3500.

z Setup Adit 3500 for access via Web-Browser

z Restore Factory Defaults

z Modify Default Admin User

z Configure WAN Interface for Internet Connectivity

z Configure the Adit 3500 as a SIP Gateway

Setup Adit 3500 for access via Web-Browser

The following steps will configure the Adit 3500 to allow access to the Web Browser for configuration,

through the LAN (1) or WAN (2) 10/100Base-T Ethernet connections.

Note: for LAN access, no additional configuration is required to access the Adit using the web browser.

To configure the WAN access:

1. Connect to the CLI via the DB-9 RS-232. See Setting up a CLI Connection on page 24.

2. Enable the remote admin WAN access with the following command sequence:

Command Description

Username: admin

Password: ********

Log into the system (username and password).

Adit 3500> enable Enter the Privileged mode.

Password: ********

Enter password for the Privileged mode.

#configure terminal

Enter the Configuration mode.

(config)# remote-admin web

primary-port enable

Enable remote web admin.