Network Device User Manual

7-36 Broadmore 1750 - Release 4.6

Configuration

CPU Redundancy

Release CPU Control

If desired, the online CPU can be made to release control (switch) to the standby

CPU by performing the following steps. The online CPU will then become the

standby CPU, and vice versa. This command may be used during maintenance

procedures.

Reboot Standby CPU

If desired, the standby CPU can be rebooted by performing the following steps.

This command may be used during maintenance procedures.

Install Single or Dual CPU

This configuration item only activates detection of the SNMP trap Standby CPU

missing. If only one CPU is present, select Single CPU. If two CPUs are

installed, select Dual CPU.

Select Maintenance/Diags ↵

Select Redundancy ↵

Select CPU ↵

Select Release CPU Control ↵

Select Maintenance/Diags ↵

Select Redundancy ↵

Select CPU ↵

Select Reboot Standby ↵

Select Maintenance/Diags ↵

Select Redundancy ↵

Select CPU ↵

Select Installed ↵