Operating instructions

7-12 Commissioning and Parameterization Rexroth IndraDrive
DOK-INDRV*-FU*********-IB01-EN-P
7.2 Parameterization
Control Panels
Standard Control Panel
Can be used with control sections CSB01, CSH01, CDB01.
Fig. 7-2: Standard control panel
The standard control panel allows the following displays:
• status of the master communication
• operating status
• activated commands and command diagnoses
• warnings and error diagnoses
• extended displays such as contents of error memories, diagnostic
message memory, operating hours counter of control section,
operating hours counter of power section, type designation of firmware
active in the device, safety technology code (if safety technology option
available)
The following settings can be made with the standard control panel:
• set the drive address (drive number in the bus system of the master
communication)
• set the length of the fiber optic cable
• activate the master communication mode "Easy Startup"
The following commands can be activated with the standard control
panel:
• activate S-0-0262, C07_x Load defaults procedure command (load
controller parameters or basic parameters)
• activate other commands, such as:
• C2200 Backup working memory procedure command
• C2300 Load working memory procedure command
• C2500 Copy IDN from optional memory to internal memory
• C2600 Copy IDN from internal memory to optional memory
Possibilities of Display of
Standard Control Panel
Possible Settings with Standard
Control Panel
Command Activation with
Standard Control Panel