CMG Router User Manual

5-24 CMG Router - Release 2.7

Profile Directory:Remote Profile

Static Addresses

Use this screen to define static addresses that are based on the Ethernet MAC or IP

Address of a specific device on the local LAN. Typically, the Adit would learn of these

devices by monitoring LAN/WAN packets. By defining a static address, you are telling

the Adit the location of the corresponding device before the Adit learns where this

device resides. Static addresses are typically used in a bridging situation.

Use the Local (LAN) Profile to define static addresses for devices that are located on

the LAN. If you wish to establish static addresses for devices on remote LAN’s, access

this screen using the corresponding Remote (WAN) Profile.

NOTE: Each static address filter will count toward the maximum number of 500

filters.

1. On the Main Menu, press [T

AB] until Configuration <Profile Directory> is

highlighted.

2. Select WAN <Setup -> on the RemoteUnit line and press [E

NTER].

Profile