CMG Router User Manual

11-4 CMG Router - Release 2.7
Router Configuration
Basic VoIP Setup
Command Description
set local off
Set the controller to use CLI commands
disconnect a:1
Disconnect all connections to the T1-1 on the
Controller (slot a)
disconnect 1
Disconnect all connections to the FXS card in slot 1
disconnect 2
Disconnect all connections to the FXS card in slot 2
disconnect 3
Disconnect all connections to the FXS card in slot 3
disconnect 6
Disconnect all connections to the router card in slot 6
set a:1 up
Set the T1 on the controller up
set a:1 fdl none
Disable FDL output messages on the DS1
set a:1 lbo 1
Sets the DS1 Line Build Out to 0-133 feet
set a:1 framing esf
Sets the DS1 to Extended Superframe (ESF) framing
set a:1 id "CAC DS1# A:1"
Sets the DS1 ID to "CAC DS1# A:1"
set a:1 linecode b8zs
Sets the DS1 line coding to B8ZS.
set a:1 loopdetect on
Enables the detection of CSU loop code on the DS1
set a:1:all type data
Set the T1-1 of the Controller, Type to Data
set a:2 down
Set the T1-2 as Out-of-Service
set clock1 a:1
Set primary master transmit clock source
set clock2 internal
Set secondary clock source
set a:2 up
Set the T1-2 as In-Service
connect a:1:1-24 6:1:1
Connect Data DS0s to the CMG card
connect 6:1:1:1-8 1:1-8
Connect CMG voice ports to FXS ports
connect 6:1:1:9-16 2:1-8
Connect CMG voice ports to FXS ports
connect 6:1:1:17-24 3:1-8
Connect CMG voice ports to FXS ports
set verification off
Disable verification prompts