User manual

Adit 600 - Release 10.1.1 13
Quick Start
Interface Connectors
Power Reset
This is a resetable circuit breaker. If at any time there is a short or power
surge on the incoming AC/DC line, the breaker will trip to protect the
Power supply from damage.
Power Connections
There are four power supplies available for the Adit 600.
 115 VAC/-48 VDC
 230 VAC/-48 VDC
 24/-48 VDC
 24 VDC with -48 Output
These power supplies have different connectors as shown in the following. For
additional information, see Chapter 15, Power Supply of the Adit 600 User Manual.
Fuse Recommendation
When using -48 VDC input power, use a 3.5 Amp fast-acting fuse if the power
connector is wired to a fuse panel.
Power Cord AC
An AC Power cord is provided with the 115 VAC and the
230 VAC Power Supplies.
To connect the Power Cord:
1. Insert power cord (male-end) to AC power source.
2. Plug connector into the Adit 600.
3. A green light should appear on the DC Input LED on the front of the Power
Supply.
AC Power Connector