User manual

16 Adit 600 - Release 10.1.1
Quick Start
Interface Connectors
2. Strip the two wires from the power
source so that approximately 5/16 inch
of bare wire is exposed. see Wire Gauge
chart below for wire recommendations.
3. Insert the Battery Return (-) and Battery
(+) wires into the appropriate square
holes, one at a time.
4. Tighten screws to clamp wires.
5. Ensure that no bare wire shows after the
wires are installed.
6. Apply power to connector.
7. Verify with voltmeter that voltage is
correct and polarity is correct.
8. Plug connector(s) into the Adit 600 DC
Power connector, as seen in the graphic
and secure with set screws
9. A green light should appear on the DC OK LED on the front of the Power
Supply.
Wire Gauge
18 AWG 16 AWG 14 AWG
Maximum Distance
12 Feet 20 Feet 35 Feet
Battery (+)
Battery
Return (-)