Infrared Remote 40KMC------301 40KMQ------301 OWNER’ S MANUAL
This control system only operates with 40KMC------301 and 40KMQ------301 Cassette indoor units. For installation instructions of this unit, refer to the relevant manuals. Contents Page General information .................................................................................... 2 Display of selected functions ...................................................................... 3 Use of the remote control ............................................................................
Infrared Remote General information year. The remote control used batteries must be disposed of according to the standards in force. • If the air conditioner does not operate normally after replacing the batteries, remove the batteries, refit them and press the reset button “O” again after 5 seconds. BEEP The remote control operates with two 1.5 V non re-chargeable batteries. When the symbol appears in the display, this indicates that the batteries are exhausted.
Infrared Remote Display of selected functions ENGLISH 1 3 2 5 4 7 6 8 10 9 11 17 12 13 15 16 14 1. Operating mode (from left to right): • Ventilation (fan only) • Heating (heat pump models only) • Automatic (heat pump models only) • Cooling and dehumidification • Dehumidification only 2. Signal transmission symbol 3. Temperature selected 4. Address selector 5. Temperature unit of measurement (°C or °F) 6. Unit configuration 7. Batteries exhausted indicator 8.
Infrared Remote Use of the remote control Current time adjusting and reset buttons (buttons N and O) Selection of the operating mode (button A) Press current time adjusting button for at least 5 seconds to adjust the current time. Press reset button “O” with a sharp object if the remote control is not operating properly or after replacing the batteries. With this button the operating mode of the air conditioner can be selected.
Infrared Remote Use of the remote control ENGLISH 7. Louver positioning Selecting the fan speed (button E) The fan speed can be selected by pressing button Now this icon is flashing. Use button , to select desired position. for confirmation. Press button Now all icons are fixed on display. If you want to cancel selections up to here inserted, push button ; if you want to cancel all options once timer has been set, push button and then . .
Infrared Remote Use of the remote control DAILY timer (Everyday - button J) Push the button when the ON or OFF timer is active. The icon will appear on display. In this way the ON and OFF timer memorization will be repeated every day. To disactivate the daily function, press again the button . SLEEP timer function with delayed switching off (Button M) Press this button to set the SLEEP timer with remote control on. The icon will appear on the display.
Infrared Remote Troubleshooting After inserting the batteries in the remote control, the display does not illuminate: • The batteries are exhausted or the polarity is incorrect; replace the batteries or check polarity. ENGLISH When pressing any function button, the remote control shows the function requested on the display, but the unit does not acknowledge the signal with a “beep” and does not carry out the function: • The remote control batteries are exhausted; replace the batteries.
L010127H32 - 0306 Via R. Sanzio, 9 - 20058 Villasanta (MI) Italy - Tel. 039/3636.1 The manufacturer reserves the right to change any product specifications without notice. March, 2006.
