Operating instructions

ManualsBrandsCarrier ManualsConditioners48/50Z030-105

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.

Catalog No. 04-53480066-01 Printed in U.S.A. Form 48/50-75SI Pg 1 8-09 Replaces: 48/50A,Z-2SI

Installation and Operating Instructions

Part Number CRSTATUS002A00

PACKAGE USAGE AND CONTENTS

SAFETY CONSIDERATIONS

Installation and servicing of air-conditioning equipment can

be hazardous due to system pressure and electrical compo-

nents. Only trained and qualified service personnel should

install, repair, or service air-conditioning equipment.

Untrained personnel can perform the basic maintenance

functions of replacing filters. All other operations should be

performed by trained service personnel. When working on

air-conditioning equipment, observe precautions in the litera-

ture, tags and labels attached to the unit, and other safety

precautions that may apply.

INSTALLATION

NOTE: The plugged filter indicator can monitor filter status

(CLEAN/DIRTY). Follow the procedures below and perform

the steps necessary to install the plugged filter indicator.

48/50A Units

1. Open the blower access door on the unit.

2. Open the filter section access door on the unit.

3. Mount the filter switch to the right of the auxiliary

control box (see Fig. 1) using two no. 6 screws.

4. Connect control tubes as shown in Fig. 1. Remove plug

bottoms, insert grommets and route tube through wall as

shown in Fig. 2. See Fig. 3 for dimensions.

5. Make electrical connections:

a. Orange wire marked PF-1 to terminal 1 on switch.

b. Brown wire marked PF-3 to terminal 3 on switch.

ITEM DESCRIPTION QTY PART NUMBER

UNIT

48/50

1 Switch 1 HK06WC029 A,P,Z

— Screw — 8-18x

in. 2 — —

— Screw — 6-20x

in. 2 — A

2 Control Tube 2 50TG501183 A

— Wire Tie 1 — —

3 Tube Fitting 1 KA70PP010 —

4 Hex Nut — #10-32 Brass 1 AT39QA131 —

5 Wire Tie 12 HY76TB045 P,Z

6 Tube Bracket 2 50DW503955 P,Z

7 Grommet 2 KA56GR140 A,P,Z

8 Control Tube 1 50NP500026 P,Z

9 Control Tube 1 50DW503993 P,Z

10 Bushing 1 HY93NH028 P,Z

11 Screw 2 AL48AM307 P,Z

WARNING

Prior to installation of this accessory, make sure all power

is disconnected to the unit and locked out. Failure to dis-

connect power supply prior to servicing may result in seri-

ous injury.

CAUTION

When removing panels from the unit, be careful not to

damage the roof or other surfaces with the panels.

48/50A020-060, 48/50P030-100,

48/50Z030-105

Plugged Filter Indicator Accessory

GROMMET

CONTROL

TUBE

FILTER INDICATOR SWTICH

LABELED PF-3

LABELED PF-1

GROMMET

CONTROL TUBE: 2" MIN LENGTH

INSERTED PAST FILTER ACCESS BAFFLE

Fig. 1 — Control Tube Routing (48/50A020-060)

Fig. 2 — Control Tube and Grommet

(48/50A020-060)

Summary of content (4 pages)

PAGE 1
48/50A020-060, 48/50P030-100, 48/50Z030-105 Plugged Filter Indicator Accessory Installation and Operating Instructions Part Number CRSTATUS002A00 PACKAGE USAGE AND CONTENTS ITEM DESCRIPTION QTY PART NUMBER 1 — — 2 — 3 4 5 6 7 8 9 10 11 Switch Screw — 8-18x1/2 in. Screw — 6-20x3/4 in.
PAGE 2
the tube. Cut excessive length of the tube. Connect the control tube to the switch port labeled “H”. See Fig. 3. For 48/50P055-100 and 48/50Z055-105 units, route the tube down the filter section upright to the auxiliary control box. Gently secure the tube using the wire ties (Item 5), making sure not to pinch the tube. Cut excessive length of the tube. Connect the control tube to the switch port labeled “H”. See Fig. 3. 6. Attach the control wires to the switch.
PAGE 3
ITEM 6 + 11 ITEM 9 ITEM 6 + 11 ITEM 8 ITEM 5 Fig. 4 — Tube Routing (48/50P030-050 and 48/50Z030-050 Units) ITEM 5 ITEM 6 + 11 ITEM 9 ITEM 6 + 11 ITEM 8 ITEM 9 Fig. 5 — Tube Routing (48/50P055-100 and 48/50Z055-105 Units) FILTER SWITCH (ITEM 1) DP BUILDING PRESSURE TRANSDUCER ITEM 7 DUCT PRESSURE TRANSDUCER BP 25 (0.98) OACFM TRANSDUCER OUTDOOR CFM SENSOR TRANSDUCER ITEM 8 AND 9 ITEM 6 Fig. 7 — Auxiliary Control Box (48/50P030-050 and 48/50Z030-050) Fig.
PAGE 4
FILTER SWITCH (ITEM 1) BUILDING PRESSURE TRANSDUCER DP DUCT PRESSURE TRANSDUCER BP OACFM TRANSDUCER OUTDOOR CFM SENSOR TRANSDUCER Fig. 8 — Auxiliary Control Box (48/50P055-100 and 48/50Z055-105) Copyright 2009 Carrier Corporation Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. Catalog No. 04-53480066-01 Printed in U.S.A.