Owner`s manual

High Wall Type
Owner’s Manual
–9–
 Names and functions of
indicators and controls on
indoor unit
Display panel
The operating conditions are indicated below.
1 OPERATION (Green)
This lamp illuminates during operation.
2 TIMER (Green)
This lamp illuminates white the timer reserved.
NOTE
When timer is set by wired remote controller,
TIMER lamp does not illuminate.
3 Preheat/Defrost (Orange)
This lamp illuminates when the power is turned on or
right after heating operation starts or during defrost
operation.
4 TEMPORARY operation
If the wireless remote control is misplaced or lost or
its batteries are exhausted, push the button.
• Push the button to start the air conditioner.
Push this button once again to stop it.
CAUTION
Disagreement in operation mode
• This model is not equipped with the Automatic
Operation feature.
If Auto changeover control is selected with the
mode selection button, “A” appears on the
remote controller display. However, the alarm
tone sounds twice from the air conditioner unit
and the Timer (green) and Preheat/Defrost
(orange) indications blink alternately on the
Display panel to tell the Automatic Operation is
not available.
• When local prohibition is set by the central
control from other equipment, no signal is
received even if the remote control button is
pressed. However, a signal of ON/OFF button
is accepted. (An alarm sound “beep” arises
intermittently five times.)
123
4
9-EN
+001111053801_00Ta.book Page 9 Friday, January 21, 2011 3:52 PM