Automobile Parts User Manual

6-- 1
62--11362
SECTION 6
ELECTRICAL SYSTEM
6.1 STARTER TEST
1. C Terminal
2. Positive Terminal
3. Negative Terminal
1. S Terminal
2. Positive Terminal
3. Negative Terminal
6.1.1 Motor Test
WARNING
Secure the starter to preventit frommoving
when power is applied to it.
1. Disconnect the cable from the negative terminal on
the battery.
2. Disconnectthecablefromthepositiveterminalonthe
battery.
3. Disconnect the leads from the starter B terminal.
4. Remove the starter from the engine.
5. ConnectajumperleadfromthestartersolenoidCter-
minal (1) to the positive battery terminal.
6. Connect a jumper lead momentarily between the
starter motor housing and the negative post on the
battery.
7. Ifthestarterdoesnotrun,repairorreplacethestarter.
Tightening Torque
B
Terminal Nut
8.8to11.8N
.
m
0.9to1.2kgf
.
m
6.5to8.7ft--lbs.
6.1.2 Magnetic Switch Test
NOTE
This test should only be carried out for a 3 to 5
second time period and not longer.
1. Disconnect the cable from the negative terminal on
the battery.
2. Disconnectthecablefromthepositiveterminalonthe
battery.
3. Disconnect the the positive cable and leads from the
starter B terminal.
4. Remove the starter from the engine.
5. Connect a jumperlead fromthe starter S terminal (1)
to the positive battery post (2).
6. Momentarily, connect a jumper lead between the
starter housing and negative battery terminal (3).
7. If the pinion gear nose does not pop out, replace the
starter.
NOTE
TheB terminal is theterminalthat connectsthe
cable from the battery to the starter.
TheS terminal is the terminalthat connectsthe
cable from the starter switch to the magnetic
switch.