Service manual

ManualsBrandsCarrier ManualsKitchen AppliancesVECTOR 6500

62−11389

TABLE OF CONTENTS − Continued

PARAGRAPH NUMBER Page

4.6 DEFROST 4−8...........................................................................

4.6.1 Defrost Initiation And Start 4−8...........................................................

a. Defrost based on coil condition 4−8....................................................

b. Defrost based on time: 4−8...........................................................

4.6.2 Defrost Modes 4−8.....................................................................

a. Normal Defrost Mode 4−8............................................................

b. Natural Defrost Mode 4−8............................................................

4.6.3 Defrost Termination 4−8.................................................................

4.7. USER SELECTED OVERRIDE OPERATION 4−9.............................................

4.7.1 Supply Air Limit Control 4−9............................................................

4.7.2 Temperature Range Lock 1 & 2 4−10.....................................................

4.7.3 ProductShield 4−11.....................................................................

4.8. PREPROGRAMMED SOFTWARE OVERRIDES. 4−13.........................................

4.8.1 Cargo Protect Mode. 4−13..............................................................

4.8.2 Compressor Minimum Operating Time 4−13...............................................

4.8.3 Engine Speed Overrides 4−13...........................................................

4.8.4 Unloader Control Overrides 4−14.........................................................

4.8.5 Defrost Safety Override 4−16............................................................

MICROPROCESSOR INTERFACE 5−1..............................................................

5.1 INTERFACE METHODS 5−1...............................................................

5.2 TECHNICIAN INTERFACE 5−1............................................................

5.2.1 Configuration Mode 5−2................................................................

5.2.2 Component Test Mode 5−2.............................................................

5.2.3 Service Mode 5−3.....................................................................

5.3 PC MODE 5−3...........................................................................

5.4 PC CARDS 5−4..........................................................................

5.4.1 Handling PC Cards 5−4................................................................

5.4.2 Program PC Card 5−5.................................................................

5.4.3 Configuration PC Card 5−6.............................................................

5.4.4 Option PC Card 5−6...................................................................

5.4.5 Download PC Card 5−6................................................................

5.5 REEFERMANAGER & REPORTS 5−6......................................................

5.5.1 Introduction 5−6......................................................................

a. ReeferManager 5−7.................................................................

b. Reports 5−7........................................................................

c. Connecting Computer and Microprocessor: 5−7.........................................

5.6 MICROPROCESSOR DISPLAY DIAGNOSTICS 5−8..........................................

5.7 MICROPROCESSOR REPLACEMENT & SETUP 5−8........................................

5.7.1 Pre-Replacement Steps 5−9............................................................

5.7.2 Microprocessor Replacement 5−9.......................................................

5.7.3 Microprocessor Setup 5−10..............................................................

5.7.4 Configurations Via Keypad 5−11.........................................................

5.7.5 Functional Parameters Via Keypad 5−11..................................................

5.7.6 DataLink Data Recorder Via ReeferManager 5−11..........................................

5.7.7 Microprocessor Final Checkout 5−11.....................................................