User manual
G
17CARSON Virus 4.0 Chassis Nitro 500204031 / 500202016
Tools Needed for the Assembly
Modelling knife 300074053
Philips screwdriver
(small and big) 1,5/ 2 /
2,5 mm 300074023
Instant adhesive 300053339
Hexagonal wrench 500905065
Needle nose pliers 300074034
Tweezers 300074003
Scissors 500013305
Side cutter 300074035
Pleasereadtheinstructionsprovidedwithyourradiosystembefore
using it.
The servos must be set at the centre position before installation. To
set the servos at a neutral position, turn on the transmitter and recei-
ver. Set the trim levers in the centre position and turn off the receiver,
and then the transmitter. The servos will be in proper neutral position
for installation.
Your Radio System (only for RTR version)
Receiver antenna
Receiverbattery
Switch
Steering servo
Transmitter
Engine
throttle servo