User manual

GB // 14
1 Remove the bodywork.
2 Insert the battery into the designated compartment.
3 Secure it with the available hook-and-loop strap.
Advice
• Non-rechargeablebatteriesarenottoberecharged.
• Rechargeablebatteriesaretoberemovedfromthetoybefore
being charged.
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
• Batteriesaretobeinsertedwiththecorrectpolarity.
• Exhaustedbatteriesaretoberemovedfromthetoy.
• Thesupplyterminalsarenottobeshort-circuited.
• Regularexaminationoftransformerorbatterychargerforany
damage to their cord, plug, enclosure and other parts.
INSERTING THE DRIVE BATTERY
We recommend for the operation of the built-in model speed
controller the LiFe drive battery which is included in delivery. But
you can use also 7.4V LiPo and 7.2V NiMH drive battery. You must
changethelocatedJumperonthecontroller.
One is for LiFe/LiPo- and other is for NiMH battery used. This is
absolutely necessary, since the drive battery is otherwise damaged:
BATT jumper to left: LiPo battery
BATT jumper to right: NiMH battery
About the TYPE jumper you can be select whether in normal mode
(ESC) or in the crawl mode (active brake) is to be moved.
Beware:
For charging the battery, only use the recommended charger. Please
consider the advice of the enclosed instructions.
Charging procedure:
1 Connect the plug-in charger to wall socket.
2 Connect the battery to the charger.
3 Battery is fully charged when the status LED changes to green.
ATTENTION!
Never recharge the battery unattended.
You can use also 7.4V LiPo- and 7.2V NiMH batteries in your car be
operated.
DESCRIPTION SPEEDCONTROLLER
CHARGE BATTERY PACK