User manual

GB // 16

TROUBLESHOOTING

Problem Cause Correction

Model doesn´t move Transmitter or chassis power switch is not

”ON“

Switch power on receiver or transmitter

Polarity or battery type is wrong Check polarity and type of battery

Batteries have run down Change batteries or charge them

Loss of control Batteries have run down Change batteries or charge them

Antenna is missing or not attached properly Attach receiver antenna

Doesn´t run straight Steering trim is not adjusted correctly Make adjustment

Front and rear wheel nuts are too lose Tighten wheel nuts

Doesn´t stop Throttle trim is not adjusted correctly Make adjustment

Doesn´t reverse Throttle trim is not adjusted correctly Make adjustment

Wrong action Control properly

Running too slowly Batteries have run down Change batteries or charge them

Motor has lost power Change to spare motor

Rear wheel nuts are too lose Tighten wheel nuts

Dust or foreign objects are inside gears Turn the power switch ”OFF“ and clean out

gears

CONTROL OF THE LED LIGHTING

1 Your RC-Car is equipped with LED-lights in the front and back-

side. You can switch on and off the lights by the transmitter in

use of the third channel.

2 The picture shows the switch which controls the third channel.

You can switch the lighting on and off with it.

CAUTION!

3 The installed lighting does not replace the daylight. Therefore,

please do not drive your model at night or in the dark. Such

obstacles can not be perceived soon enough. Thank you and

have fun!

Switch

for the 3.

Channel