User manual

G
40 CARSON X8E Chassis 500409015 / 500409016
4S – Basic Settings
Throttle range setting (throttle range calibra-
tion)
InordertomaketheESCfitthethrottlerangeofyourtransmitter,you
must calibrate it for the following cases; otherwise the ESC cannot
workproperly.
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the throttle lever, the
ATV or EPA parameters, etc.
Note 1
The“SET”keyofESCisatthepowerswitch(seepicture).
Note 2
Ifyoudon’treleasethe“SET”keyassoonastheredLEDbeginsto
flash, the ESC will enter the program mode. In such case, please switch
off the ESC and re-calibrate the throttle range again as described.
Release the SET key as soon as the red LED flashes.
Thereneedtobeset3points.Theyaretheendpointof“forward”,the
end point of ”backward” and the neutral point. The following pictures
showhowtosetthethrottlerangewithyourtransmitter.
A) Switch off the ESC and turn on the transmitter.
B) Holdthe“SETUP”-keyoftheESCandthenswitchontheESC.
 Releasethe“SETUP”keyassoonastheredLEDbeginstoflash.
C) Set the 3 points according to the steps.
1. The neutral point
Movethethrottleleverattheneutralpoint,andthenclicktheSETkey.
The green LED flashes 1 time.
2. The end point of forward direction
Move the throttle lever at the end point of forward direction, and then
clicktheSETkey,thegreenLEDflashes2times..
3. The end point of backward direction
Move the throttle lever at the end point of backward direction, and
thenclicktheSETkey,thegreenLEDflashes3times.
The throttle range is calibrated; the motor can be started after 3
seconds.
Hold the SET
key
Switch on
ESC
Press and hold