User manual

GB // Instruction Manual
The switch modules are connected directly to a RC
receiver and can be controlled via a pushbutton, switch
or joystick. The position of the switch (up and down) and
the duration (short and long) are evaluated here. In the
case of the 2-way module, only the position is evaluated.
It should be noted that the pushbuttons and switches
have a middle position.
Every switching output has a memory function, i.e. it
remains activated until the switch has been returned
to the neutral position and then brought into the same
position again.
The number of separate negative switching outputs
available on the switch modules is 4 and 2 respectively.
Each of the outputs has a blue lead 20cm in length. This
lead must be connected to the consumer’s negative
terminal. Each switching output can switch a maximum
current of up to 2.5A. The maximum permissible supply
voltage is 16V.
The switch module gets its supply via the voltage of the
servo lead. The black negative lead can be connected
directly to the battery or to the distribution terminal.
With high loads it is imperative to connect the black lead
to avoid damage to the receiver.
SWITCH MODULES
TECHNICAL DATA
Input voltage: 4 - 8V from the receiver
Input current: Approx. 18mA at 5V
Outputs: 2 or 4 off
Switching voltage: Maximum 16V
Switching current: Maximum 2.5A per output
Connecting leads: Outputs: 2/4 blue silicone leads each 200mm in length and 0.25
mm²
Servo connection: 300 mm servo lead with UNI connector
Negative lead: Silicone lead 200 mm in length and 0.5 mm²
Dimensions: 16 x 14 x 4 mm
Weight: 10 g