Instruction Manual

17 // GB
ON
TURN ON THE RC SYSTEM
CAUTION!
Always turn the transmit
-
ter´s power switch ON first!
Please change batteries when LED
status flashes on transmitter!!!
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.
1
INSTALLING THE TRANSMITTER BATTERIES
1. Open the battery compartment lid on the underside of the
transmitter.
2. Insert fully charged rechargeable batteries or new AA bat-
teries observing the correct polarity. Close the cover on the
battery compartment again. Ensure that the cover clicks
properly into place. Check that it is in its correct position.
BINDING
Connecting transmitter and receiver:
The vehicle is ready to drive when it leaves the factory. In normal
circumstances, therefore, the binding function is not necessary!
The binding function should only be used if there are any connec-
tion problems between the vehicle and the transmitter or if the
transmitter/receiver is replaced. 
Switch on the receiver. The LED on the
receiver then flashes rapidly!
Press and hold down the Binding button
on the transmitter and then switch on the
transmitter. The LED flash green.
The binding process is completed when
the LED on the receiver is permanently and
on the transmitter green illuminated.
2
LED
1 2
LED
3
LED
ON
ON/OFF
1x ON
3sek. OFF
ON/
OFF