User Manual

36 CARSON DRAGSTER Brushless-Regler

6. Setting the electronic speed controller by

means of the setup card

1. Connect the ESC to a suitable charged battery pack. Make sure the polarity is

correct.

2. Connect the receiver cable to the program card, making sure of the correct

polarity.

3. Select the desired function for your speed controller and insert the jumper

(connector) in the appropriate places.

4. Turn on the ESC and wait a few seconds. The red LED on the program card will

flash, then becomes solid to indicate settings are saved.

5. Turn off the ESC and unplug the program before use again.

Trouble-shooting

If the red LED on the program card does not light up, make sure the receiver cable

is connected with the correct polarity and make sure the battery pack is fully

charged.

LED

RX (receiver)

connection

Jumper

The following values

can be set using the card:

1Motor Timing

2Acceleration

3 Setting the braking power

4 Choice dragbrake

5 Choice of rotation

6 Choice of battery type