User's Manual

Table Of Contents

MP-250

Micro

Flip

™

100x–250x Zoom Pocket

Microscope

Adapter clip

Eyepiece

LED switch

Focusing ring

Install the battery

Slide op

en the battery door (Fig.1).

2. Install 1 (one) AA alkaline battery with the correct polarity (Fig.2).

3. Attach the battery door (Fig.3).

Fig.1 Fig.2 Fig.3

Instructions for Use

UV light switch

Zooming dial

Battery door

Front Facing LED

Base plate

Objective lens

UV light

Downward

Facing LED

PAGE 1
MP-250 MicroFlip™ 100x–250x Zoom Pocket Microscope Instructions for Use Adapter clip Eyepiece UV light switch Zooming dial LED switch Battery door Base plate Focusing ring Front Facing LED Objective lens Downward Facing LED UV light Install the battery 1. Slide open the battery door (Fig.1). 2. Install 1 (one) AA alkaline battery with the correct polarity (Fig.2). 3. Attach the battery door (Fig.3). Fig.1 Fig.2 Fig.
PAGE 2
Using the microscope to view objects directly 1. Make sure the base plate sits behind the battery door in the upright position (Fig.4). 2. Press the LED switch to turn on the LED (Fig.5). only front facing LED will illuminate. Please note that when base plate is in upright position 3. Place the viewing object directly below the objective lens (Fig.6). Fig.4 Fig.5 Fig.6 Using the microscope to view specimen slides 1. Flip the base plate down so that it sits on the base of the microscope (Fig.7). 2.
PAGE 3
Using the adaptor clip Fig.13 Fig.15 Fig.14 Attach the adapter clip to the top of the microscope as shown in Fig. 14 and turn on camera. Refer to page 2 for procedures of using the microscope. If viewing image is not centered or is not a complete round image, adjust adapter clip making sure it is centered over camera. Align the camera of the phone to the center of the circular hole of the adapter clip (Fig.13). WARNING: Always hold the phone securely during use.