User Manual

User Manual DPM-816 PRO Page 12
Operating modes
The device has 5 operating modes: A, M, P, F(Fe), N(nFe).
To switch between these modes, shortly press the button,
which will switch modes in a loop. The current mode will be shown
on the display.
A - Auto: Quick measurement with automatic selection of
measurement method. Dynamic resolution. Great for checking the
car body.
M - Manufacturing: Detailed and precise measurements with
high resolution across the entire range. Automatic selection of
measurement method. It is recommended to complete the two-
point calibration before measuring in this mode.
P - Program: Measurement using six points of reference for
custom calibration. Automatic selection of measurement method.
To use this mode, completing the six-point calibration is required.
This mode is designed for cases where the standard factory
calibration of the sensor is not suitable. For example, when
measuring coating thickness on a substrate with properties vastly
differing from steel and aluminum.
F(Fe) - Magnetic induction method: Quick, continuous
measurement (4 measurements per second) of coating thickness
on a ferrous metal substrate, using magnetic induction. For
accurate measurements, it is recommended to complete the two-
point calibration before measuring.