User Manual

User Manual DPM-816 PRO Page 13
N(nFe) - Eddy current method: Quick, continuous measurement
(4 measurements per second) of coating thickness on an
aluminum alloy substrate, using eddy current. For accurate
measurements, it is recommended to complete the two-point
calibration before measuring.
Units of measurement
For user convenience, the device can display the results of
measurement in several units of measurement: millimeters, mils,
and micrometers.
The choice of units of measurement is made with short
consecutive presses of the button, which will switch units
in a loop. The current unit will be shown on the bottom right corner
of the display.
Taking the measurement
Turn on the device (see the "Turning on the device" section
above) and wait for automatic calibration to complete. After
automatic calibration (takes 2-3 seconds) the display will show
dashes.
If necessary, select the desired mode and unit of measurement in
which you want to get the result.