User Manual

User Manual DPM-816 PRO Page 14
Taking measurements in A, M, P modes (automatic modes):
Firmly place the device sensor flat against the surface to be
measured. Do not move the device during measurement (until a
sound signal is emitted), otherwise the measurement may be
inaccurate.
Once the device detects that the sensor is on the surface in a
fixed position, you will hear a sound signal indicating the
completion of measurement. Move the device away from the
measured surface. The display will show the result for 30 seconds
- the measured coating thickness and method of measurement:
Fe (magnetic induction, ferrous metals) or nFe (eddy current, non-
ferrous metals).
The accuracy of measurement depends on how flatly and firmly
the device sensor is pressed against the measured surface.
If you are using the sample plates included in the set to measure
or calibrate, the measurement must be taken from the center of
the plates.
Taking measurements in F(Fe), N(nFe) modes (continuous
measurement):
In these modes, the device takes measurements quickly and
continuously. To take measurements, place the device sensor
against the surface to be measured. The device will immediately
and continuously (4 times per second) display the result of the
measurement.