User Manual

User Manual DPM-816 PRO Page 21
The display will show "F-1" - the next point of calibration, and the
device will show the recommended thickness of calibration plate
for the current point of calibration.
Take a measurement of the metal base together with the
calibration plate. If necessary, repeat the measurement.
Use the and buttons to calibrate the displayed
thickness of the measured calibration plate, and shortly press the
button to proceed to the next point.
Repeat the procedure for each point of calibration.
After saving the last point, the display will show "8888",
and the device will switch to operating mode "P".
Repeat the procedure if necessary, for the second type of metal
base.