User Manual

CABINET MAINTENANCE

CASTERS

Caster bearings may be equipped with Zerk grease fittings so that

they may be easily lubricated with a grease gun. Lubricate bear-

ings at least once every six months.

STACKING FOUR– AND FIVE-SHELF UNITS

This task takes about 30 minutes & requires two people.

1. Using a screwdriver, remove the screws that attach the top on

the unit that you wish to be on the bottom of the stack (unit

#1). Remove the cover and set aside.

2. Place a large piece of cardboard, moving blanket or other pro-

tective material on the floor. For the other unit (unit #2), care-

fully tip it onto one of its sides (not the front or the rear). Then,

using a wrench, remove the bolts that attach the casters to the

bottom of the unit #2. Set casters aside.

3. Tip unit #2 back to an upright position. Lift and place unit #2 so

it nests in the open top of unit #1, taking care to line up the

holes where the screws were removed.

4. Replace screws into the top edge of unit #1, securing it to the

bottom of unit #2.

5. Keep extra top and casters on hand for spare parts, or if you

should ever wish to separate the units.

WARNING:

DO NOT perform

these procedures

while the cabinet is turned on

or heated. Turn off the power

and wait for the cabinet to cool

to room temperature.