Quick Reference Guide

c
SRS 6.5
STUDIO REFERENCE SERIES
IMPEDANCE: 8 Ω
MAX INPUT POWER:
125 WATTS PROGRAM
Serial No.
DCM1000
POWER AMP
MIXER or
TAPE output
MIXER or
TAPE output
c
SRS 6.5
STUDIO REFERENCE SERIES
IMPEDANCE: 8 Ω
MAX INPUT POWER:
125 WATTS PROGRAM
Serial No.
LEFT
RIGHT
LEFT
RIGHT
INPUT
POWER
BALANCED XLR
PIN 1 GND
PIN 2 SIGNAL +
PIN 3 SIGNAL -
Serial No.
– 12dB PAD
IN
OUT
90 – 250VAC~50-60Hz 125VA
O
N
O
F
F
MADE IN THE
U S A
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION - TO PREVENT ELECTRICAL SHOCK DO NOT DEFEAT THE SAFETY
GROUND ON THE POWER CORD - DO NOT REMOVE COVER .
WARNING - TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE TO RAIN
OR MOISTURE. REFER SERVICING TO QUALIFED PERSONNEL.
c
SRS 6.5A
STUDIO REFERENCE SERIES
BIAMPLIFIED CLOSE FIELD
REFERENCE MONITOR
30 WATTS @ 8 OHMS (HIGH FREQUENCY)
70 WATTS @ 8 OHMS (LOW FREQUENCY)
INPUT
POWER
BALANCED XLR
PIN 1 GND
PIN 2 SIGNAL +
PIN 3 SIGNAL -
Serial No.
– 12dB PAD
IN
OUT
90 – 250VAC~50-60Hz 125VA
O
N
O
F
F
MADE IN THE
U S A
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION - TO PREVENT ELECTRICAL SHOCK DO NOT DEFEAT THE SAFETY
GROUND ON THE POWER CORD - DO NOT REMOVE COVER .
WARNING - TO PREVENT FIRE OR SHOCK HAZARD DO NOT EXPOSE TO RAIN
OR MOISTURE. REFER SERVICING TO QUALIFED PERSONNEL.
c
SRS 6.5A
STUDIO REFERENCE SERIES
BIAMPLIFIED CLOSE FIELD
REFERENCE MONITOR
30 WATTS @ 8 OHMS (HIGH FREQUENCY)
70 WATTS @ 8 OHMS (LOW FREQUENCY)
LEFT
RIGHT
LEFT
RIGHT
CRITICAL LISTENING POSITION
2 SPEAKER (stereo) AND 5.1 (surround) SPEAKER ARRANGEMENT:
The woofers should be in vertical alignment with ears, 2-3 feet away from you and
the speakers should have a distance apart from one another by 3 feet.
2-3 FT.
2-3 FT.
3 FT.
3 FT.
6 FT.
TROUBLE SHOOTING
The SRS6.5A features a -12dB input attenuation switch for use with hotter inputs. It
also features thermal and overload protection circuit that shuts the unit down for
approx. 500 msec. before attempting to power on again. If an overload problem is still
present after the unit has cycled power, it will return to protect mode and the cycle will
continue until the problem has been fixed or the unit is manually powered down. If your
speaker starts this protect cycle, simply reduce your input level to the unit. This should
cure an over current condition. If the speaker continues the protect cycle after reducing
the input level, the unit is probably in thermal protect cycle. Turn the power off and wait
approximately 5 minutes for it to cool down before powering up. For optimal cooling
be sure that nothing is blocking the rear vents.
CONNECTION DIAGRAM
16 Gauge 2 conductor wire
SRS6.5A
SRS6.5