OWNER'SMANUAL Stereo Power Amplifier CAD 200, CAD 500

6
SPECIFICATIONS ___________________________________________________
This section describes the basic specifications of the CAD 500 MB or CAD 200 power amplifiers at the time
of printing. Specifications are subject to change without notice or obligation. When the following
cautionary terms are used in this manual, these definitions apply:
WARNING
Electrical hazard! Misuse or failure to follow instructions properly may result in personal injury
or death!
CAUTION
No risk or personal injury; however, misuse or failure to follow instructions may result in
damage to equipment.
NOTE
No risk of personal injury or equipment damage; however, misuse or failure to follow
instructions may prevent proper performance of the equipment.
........................................................................................................................................................................................................................
RATED POWER OUTPUT
CAD 500 MB 500 watts @ 8 ohms, 1,000 watts @ 4 ohms, Class A/B
CAD 200 200 watts/channel - 8 ohms, Class A/B x 2
350 watts/channel - 4 ohms x 2
........................................................................................................................................................................................................................
DAMPING FACTOR >100 @ 8 ohms
........................................................................................................................................................................................................................
PEAK CURRENT CAD 500 MB - 70 amps
CAD 200 - 35 amps
........................................................................................................................................................................................................................
FREQUENCY RESPONSE 10 to 50 kHz +/-0.1 dB
-3 dB @ 200 kHz
........................................................................................................................................................................................................................
INPUT POWER REQUIREMENTS 117 VAC 50/60 Hz or 234 VAC 50/60 Hz, by market
........................................................................................................................................................................................................................
POWER CONSUMPTION 255/155/115/90/125 Watts – Idling with no signal input
2500/1000, All channels, 8-ohm load, full power
........................................................................................................................................................................................................................
INPUT IMPEDANCE 44k ohms - Single-ended RCA inputs
91k ohms - Balanced XLR inputs
........................................................................................................................................................................................................................
OUTPUT IMPEDANCE 4 to 16 ohms rated speaker impedance
........................................................................................................................................................................................................................
GAIN 27 dB
........................................................................................................................................................................................................................
THD < 0.05 %, 20 Hz-20 kHz
........................................................................................................................................................................................................................
NOISE > 100 dB below rated output, A-weighted