User's Manual

by
a electriCAL shock.
Τρουβλε−σηοοτινγ
Perform the required specification again in Calibration mode.
CH 02
≤ Ρεασον
The load cell is connected wrongly or A/D conversion part has a
fault.
Τρουβλε−σηοοτινγ
Check that the load cell is well connected with main unit.
CH 03
≤ Ρεασον
The indicator can't be initialized due to platform shaking.
Τρουβλε−σηοοτινγ
Put the platform on a flat place without shaking and power on.
CH 04
≤ Ρεασον
The initial zero range exceeds above 10% of maximum capacity.
Τρουβλε−σηοοτινγ
Check the platform.
CH 05
≤ Ρεασον
pressing any key for long time or having problems in key part.
Τρουβλε−σηοοτινγ
If it can't be found problems in key part, CALl A/S.
noprt
≤ Ρεασον
When it is setting F13=0 or when you press print-key to print current
and unit
weight at count mode.
Τρουβλε−σηοοτινγ
If you want to print, do it in setting F13=1.
And don't print unit weight, current weight at count mode.
Over
≤ Ρεασον
The gross weight is over maximum capacity.
Τρουβλε−σηοοτινγ
Don't load the article whose weight is heavier than the maximum
capacity
(2)
In Calibration Mode
CH 11
≤ Ρεασον
Resolution(Maximum Capacity / Minimum Division) is over the limit
(1/10,000)
Τρουβλε−σηοοτινγ
Lower the resolution in any of the below ways.
(1) Modify Maximum Capacity in CAL 1 of CAL Mode.