Owner Manual

www.CasablancaFanCo.com
1.888.227.2178
M8550-01 • 07/19/18 • © 2018 Casablanca Fan Company
Light Kit
Screw two switch housing assembly
screws, found in the hardware
bag, halfway into the mounting
plate on the bottom of the motor
housing. It does not matter which
two screw holes you choose.
Make sure the LED assembly is securely attached to
the mounting plate. Failure to properly secure all 3
assembly screws could result in the switch housing
xture falling.
Feed the two single-pin connectors
through the center hole of the LED
assembly, then wrap the keyhole
slots around the screws and twist
counterclockwise.
Insert the third screw, found in
the hardware bag, into place and
then tighten all three screws.
15