Owner Manual

www.CasablancaFanCo.com
1.888.227.2178
18
M8550-01 • 07/19/18 • © 2018 Casablanca Fan Company
3
Installing the Wall Plate Bracket
Snap the Wall Control into the
Wall Plate Bracket.
4
Wiring the Wall Control
1. Connect the grounding wire
from the wall control to the
ground control from the switch
box using the provided wire
nuts.
2. Connect the “LIVE IN” from
the switch box to the “~VAC”
from the wall control using the
provided wire nuts.
3. Connect the “LIVE OUT” from
the switch box to the “FAN” out
from the wall control using the
provided wire nuts.
4. Push all wires into the switch
box.
Wall Control For Single Switch
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Ensure the power is OFF at the outlet
box and wall switch location before
proceeding with installation.
Turn Power
OFF
1
Turning off the power
2
Installing the baery
To access the baery compartment,
slide the baery door up.
Replace the used baery with two AAA
baeries when needed.
Battery
Door
If you have a dual switch setup, go to page 18
for dual switch installation instructions.