Troubleshooting guide

Casablanca Fan Co. - Factory Service Department - Technical Library
9
VERSA•TOUCH 2 © PLACING CONTROL INTO THE HOLDER
VERSA•TOUCH 2 © ( W-72 ) IF FAN DOES NOT WORK
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly in
the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at
least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push
the Hi, Med, and Low buttons–in that order–within 20 seconds.
Step 4. The fan should now function properly.
CIRCUIT BREAKER
OR FUSE BOX
PRESS IN THIS ORDER TO
SET NEW FREQUENCY:
1. HI 2. MED 3. LO
VERSA•TOUCH 2 © ( W-73) IF FAN DOES NOT WORK
CIRCUIT BREAKER
OR FUSE BOX
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly in
the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at
least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push
the Hi, Med, and Low buttons–in that order–within 20 seconds.
Step 4. The fan should now function properly.
PRESS IN THIS ORDER TO
SET NEW FREQUENCY:
1. HI 2. MED 3. LO
Removing Control
Gently Pull the lower edge of the
control out from the holder.
Control Storage
Angle control in top first until the
unit can be gently pushed back
and snapped into place.