Troubleshooting guide

Casablanca Fan Co. - Factory Service Department - Technical Library

VERSA•TOUCH 2 © CHANGING FREQUENCY SETTING

You will only have to change the dip switch settings in the

remote if you are using more than one fan in the same area and

want to control them separately.

Step 1. At the circuit breaker or fuse box, turn the power off for

the fan you want to change.

Step 2. Open the battery door of the Versa•Touch control and

remove the batteries.

Step 3. Change the dip switch settings, assuring that they are

different from the previously installed Versa•Touch fan.

Step 4. Re-install the batteries and the battery door on the

control.

Step 5. At the circuit breaker or fuse box, turn the power back

on for the fan whose frequency you are changing.

Step 6. Within 20 seconds of restoring power, push the Hi,

Med, and Lo buttons (in that order).

Note: All fans leave the factory set to ‘00000’.

WITHIN 20 SECONDS OF TURNING THE

POWER ON, PRESS IN THIS ORDER TO

SET NEW FREQUENCY:

1. HI

2. MED

3. LO

Note: You may want to label your controls to

assure you do not mix them up.

WARNING: Do not turn the power off at the circuit

breaker, then back on, for the previously installed

Versa•Touch 2 fan(s), as you may inadvertantly change

the frequency settings for it as well.