Instructions / Assembly

cylinder / regulator connection (Figure 19)

natural gas fixture / natural gas supply

system connection (Figure 20)

gas valve / bellows connection (Figure 21)

Figure 18

BATTERY

LEAK TEST

WARNING:

1. Please observe proper polarity and use the correct battery type when installing or replacing the battery. Improper

installation could result in ignition failure.

2. Please remove the battery if consumed or if product is to be left unused for a long period of time.

1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is

connected for use.

2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.

3. Conduct the leak test outdoors in a well-ventilated area.

4. Do not use matches, lighters or a flame to check for leaks.

5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak, disconnect the

propane supply and call a gas appliance service shop or your local propane gas supplier.

To prevent fire or explosion hazard when testing for a leak:

Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located on the

control panel to access the battery compartment. The ignitor module requires one AAA size battery, (see Figure 18).

BATTERY IS NOT INCLUDED.