Instructions / Assembly

CAUTION: Please be advised that this fire pit is equipped with natural lava rock that may crackle or pop the

first time it is used. The lava rock has been pre-heat treated to release any natural inherent moisture. How-

ever, in rare cases on first time use, the lava rock may pop or burst causing small pieces of hot rock to

potentially be a projectile. These hot pieces could cause injury or property damage. As a precaution, please

follow these instructions the first time the fire pit is used:

(1). On first use, do not stand over or near the fire pit once lit.

(2). Light the fire pit and let it run on high for 20 minutes.

(3). Once lit, do not go within 12 feet of the fire pit for at least the first 20 minutes on the first use to ensure

any residual moisture trapped in the rocks gets released.

(4). After the first heating cycle there is little further concern. It is rare that any crackling will happen on the

first use, this is simply a precaution.

(5). Keep lava rock covered and dry while not in use to prevent additional moisture from getting in the rocks.

(6). If lava rocks are exposed to moisture after first use, run the burner on low to gradually warm and dry the

rocks before repeating steps 1 through 3.

Figure 9

9. Open the box of lava rocks, put the lava rocks (L) into the fire bowl of the fire table, (see Figure 9). A gas fire pit

requires 13.2 lbs lava rocks.

WARNING: Keep children away during assembly, as this item contains lava rock, which are small pieces and can

be swallowed by children.

NOTE: Leave the pilot box uncovered by the lava rock.

pilot box