Specification

1:The battery box should be lean against the wall or on the ground. Cable should
not be intertwined.
2:Insulating spacer must be used to isolate faucet and metal mounted surface.
Insulating spacer is not necessary if mounted on an insulating surface (such as
ceramic basin, etc).
3:Hot and cold water inlets and the draw tube should be insulated (PVC or silicone
hose are recommended).
Insulated water inlet hoses
6
Insulation spacer 1
(install on top of the deck, only apply to metal deck)
Insulation spacer 2
(install underneath of the deck, only apply to metal deck)
3. Installation Condition
1.When you open the package, please check the parts according to the standard
part list, please contact the distributor if it is breakage.
2.The body is under testing by the factory, please don't dismantle.
3.Please make sure to clean the impurity and sludge in the hose before assembly
in case of the effection of the inusing function.
4.Please check if there is leakage after assembly.
5.Medium temperature shall not be greater than 90°C
6.Installation water pressure: 0.1Mpa<water pressure<1.0Mpa .
7.When tighten the connecting nut can not be greater than 10nm.
8.Don't over bend the hose and ensure no hose deformation after installation.
4.Cleaning & Maintenance
To keep the product clean & shining, follow as below.
1: Flush with clean water & dry with soft cloth only.
2: If any dirt, clean with soft liquid or transparent glass detergent.
3: Do not use any scrubbing detergent, polisher, sane-cloth, paper tissue or scraper.
4: Do not use acid detergent, in discoverable grain-like detergent or soap.
5.Guarantee
This product comes with guarantee (please refer to the seller for details of
guarantee) when installed, used and cleaned in accordance with this manual.
Not covered by the guarantee Is:
• Breakdown due to -
a) Use other than domestic
b) Willful act neglect
c) Any malfunction resulting from incorrect use
d) Incorrect setting of controls
e) Any malfunction resulting from poor water quality
• Repair costs for damage caused by foreign objects or substances.
• Total loss of the product due to non-availability of parts.
• Compensation for loss of use of the product or consequential loss of any kind.
• Call out charges where no fault has been found with the product
NOTE：
The guarantee on the cartridges and valves is invalidated if damage is caused by
waterborne debris.
NOTE：
All products must be installed in a manner providing access for servicing or
replacement during the life of the product.
We have a policy of continuous improvement and reserve the right to change
specifications without notice.
Please retain this document for future reference.
Not covered by the guarantee is:
• The cost of repair or replacement of pressure relief devices, spray heads, hoses,
riser rails and/or wall bracketor any other accessories installed at the same time.
• The cost of routine maintenance, adjustments, overhaul, modifications, loss or
damage, arising therefrom, including the cost of repairing damage, breakdown,
malfunction caused by corrosion, furring, pipe scaling, lime scale, system debris or
frost.