Installation Guide

Table Of Contents

2、The size of counter basin's hole as above.

1. Ensure that the water supply below your sink is

completely shut off by turning the shutoff valves

all the way to the right.

Tip: Place a small bucket below your workspace

to catch any water that may drip during the

installation process.

3、Slide the washe(0-ring) tofaucet base. Insert

the new faucet through sink.

PAGE 1
. Ensure that the water supply below your sink is completely shut off by turning the shutoff valves all the way to the right. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. 2、The size of counter basin's hole as above. 3、Slide the washe(0-ring) tofaucet base. Insert the new faucet through sink.
PAGE 2
4、Prepare to install the undemeath receiver.Install washer on nut and tee joint. 7、Tighten the handles. 5、Insert rubber washer, then insert trident joint. Tightentrident and align with valve. Tighten coupling nut'and insert trident. 8、 Connect and tighten the hoses with hot and cold Water supplies. Tum on Water supplies,tum the handie, flush thehot andcold watre for 1 minute. 6、Insert hot and cold water handles through the hole. Put on fitting accessories in correct order.