Manualshelf

Instructions / Assembly

ManualsBrandsCASAINC ManualsLighting3-Light White Dome Dimmable Bath Wall Lantern Sconce
1
Assembly & Installation Instructions
MODEL: A40022、A40023、A40024、A40025、A40026
IMPORTANT SAFETY INSTRUCTIONS:
•
Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure
full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.
•
Warning: This product can expose you to chemicals including lead, which is known to the State of
California, to cause cancer or birth defects or other reproductive harm. For more information,
please go to www.P65Warnings.ca.gov
•
Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass
component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker
panel before beginning installation.
Important Notice:
This is a generic instruction sheet used for various fixtures.
The finish, shape and style of fixture / glass / shade / diffuser may vary.
(Required Supply Circuit: 120V, 60Hz. Bulb Type: 3*E26*60W Max)
Compatible Bulb Type
(NOT Included)
The mostly suggested bulb type is 8W LED ST58 or A19 bulb
COMPONENTS INCLUDED IN THE PACKAGE
Fixture with hardwares
Parts included in parts bag
Parts X 2 for 2 pack item
ASSEMBLY & INSTALLATION STEPS:
1. Open the box from top, take out all the components, parts bag and manual from the box carefully.
2. Check all the components against the parts list. Make sure get each parts on list. If any parts missing
and glass damage, please contact the seller to get a replacement.
Parts are NOT included for which is shown as 0 under QTY.
PARTS LIST (Parts QTY X 2 for 2 pack item)
Part Name
QTY
Code
Part Name
QTY
Code
Junction Box
0
A
Wire Nut
3
I
Leading Wire
0
B
Wire
2
J
Mounting Screw
2
C
Socket
3
K
Cross Bar Mounting Bracket
1
D
Lamp Shade
3
L
Stud
2
E
Light Bulb
0
M
Backplate
1
F
Socket Ring
3
N
Washer
2
G
Finial
2
P
Cap Nut
2
H
Lamp Body
1
Q
3. Refer to the illustration while doing assembly and follow the steps as below:
I
Screw on the decorative head (P) to the lamp body(Q)
II
Assemble the lamp shade (L) to the socket (K), fix with the socket ring (N).
Screw on the bulb (M) to the socket or do this step after intallation.
III
Thread two studs (E) onto the mounting bracket (D) at proper position.
IV
Attach the mounting bracket (D) to the junction box (A) by two mounting screws (C).
Adjust the mounting bracket to make the fixture installed at a horizental level.
V
Connect wires according to the wiring diagram as below.
VI
Attach the backplate (F) to two studs (E) and fix with two washers (G) and cap nuts (H).
Illustration of assembly and wiring:
I.
P
Q
II.
L, N, M
K
III.
E
D
IV.
C, D
A
V.
B, J
I
VI.
G, H, F
E

Summary of content (1 pages)