Instructions / Assembly

ManualsBrandsCASAINC ManualsLighting1-Light Black Dusk to Dawn Outdoor Square Wall Lantern Sconce

Assembly & Installation Instructions

MODEL: F200002、F200002P

IMPORTANT SAFETY INSTRUCTIONS:

•

Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure

full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor.

•

Warning: This product can expose you to chemicals including lead, which is known to the State of California,

to cause cancer or birth defects or other reproductive harm. For more information, please go to

www.P65Warnings.ca.gov

•

Caution: Electrician installation highly recommended. All glass is fragile, use care when handling glass

component(s) and or lamp(s). Read instructions carefully and turn electricity off at the main circuit breaker

panel before beginning installation.

Important Notice:

This is a generic instruction sheet used for various fixtures.

The finish, numbers of heads/arms, and style of fixture / glass / shade / diffuser may vary.

(Required Supply Circuit: 120V, 60Hz. Bulb Type: 1*E26*60W Max)

Compatible Bulb Type

(NOT Included)

The mostly suggested bulb type is 8W LED ST58

COMPONENTS INCLUDED IN THE PACKAGE

Fixture with hardwares

Parts included in parts bag.

Parts X 2 for 2 pack item

ASSEMBLY & INSTALLATION STEPS:

1. Open the box from top, take out all the components, parts bag and manual from the box carefully.

2. Check all the components against the parts list. Make sure get each parts on list. If any parts missing

and glass damage, please contact the seller to get a replacement.

Parts are NOT included for which is shown as 0 under QTY.

PARTS LIST (Parts QTY X 2 for 2 pack item)

Part Name

QTY

Code

Part Name

QTY

Code

Junction Box

Washer

Leading Wire

Socket

Wire Nut

Light Bulb

Wire

Glass

Universal Mounting Bracket

(1") Mounting Screw

Back Plate

Screw

3. Refer to the illustration while doing assembly and follow the steps as below:

Screw on the bulb (K) onto socket (J) before installation.

Attach the mounting bracket (E) to the junction box (A) by two mounting screws (F).

Adjust the mounting bracket to a horizental level.

III

Connect wires according to the wiring diagram as below.

Attach the backplate (G) to mounting bracket (E) and fix with two washers (I) and screws (H).

Illustration of assembly and wiring:

I. K

II. E,F

III. B, D

IV. I,G,H

Summary of content (1 pages)

PAGE 1
Assembly & Installation Instructions MODEL: F200002、F200002P IMPORTANT SAFETY INSTRUCTIONS: • Warning: If any special control devices are used with this fixture, follow the instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electric contractor. • Warning: This product can expose you to chemicals including lead, which is known to the State of California, to cause cancer or birth defects or other reproductive harm.