User's Manual

THE INTERFACE SCREENS
The Cyclone backhaul module contains a series of web pages that are used to interface to the
unit. The following is a quick reference to interface screens. Note: These screens are subject to
change by subsequent software versions. To access the web based interface you first must be on
a computer that is in some way connected to the access point module. This can be done either
directly or through a network. Enter the IP address of the backhaul module (default is
169.254.1.1) into the address bar of your browser and hit enter on your keyboard.
The backhaul module will have two different sets of interface screens, one for the timing master
and one for the timing slave. The master and slave’s interface screens are very similar to that of
the access point module and subscriber module respectively.
The following web based interface pages are accessible:
Timing Master Timing Slave
Quick Start Status
Status Configuration
Configuration Event Log
Event Log AP Eval Data
LUID Select Ethernet Stats
Link Test Extended Stats
Time & Date
Sessions
GPS Status
Ethernet Stats
Extended Stats
THE TIMING MASTER
QUICK START
The Cyclone System consists of a family of highly flexible, fixed wireless access devices that can
be put into service quickly and with a minimal configuration. The Quick Start is a wizard that
walks the operator through that configuration. To place an access point module into operation,
only three parameters need to be configured:
RF Carrier Frequency
Synchronization
Network IP Address
Each of the pages in the Quick Start will explain a little about Cyclone and ask the operator for a
choice that best addresses the network requirements. At the end, the operator will be given the
opportunity to review the configuration selected and save it to non-volatile memory. None of the
changes made prior to saving the configuration will affect the system so experimentation with the
interface is encouraged.
Page 8