Installation Guide

Fixture Wire
Chain
Mounting Screw
Nipple(-a)
Fixture Grounding Wire
Collar
Top Loop
Canopy
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Outlet Box
House Grounding Wire
Loop Lock
Hook
Bushing
The Side Hole
Upper Fixture
Nipple(-b)
Cap
Coupling
Holder
Hex Nut
&Washer
Socket Ring
Socket Ring Fixer
Glass Shade
Glass Holder
Loop Lock
1. Attach nipple(-a) to the mounting strap, then secure it with
a washer and hex nut.
2. Attach the mounting strap to the outlet box by using two
mounting screws.
3. Screw nipple(-b) into coupling and secure it with a washer
and hex nut. Then attach the cap with the open side facing
downward and the upper fixture to the holder by inserting
nipple(-b) and secure them with the hook.
Note: To avoid the damage of the wire, placing the bushing
at the side hole of the hook while pulling the wires out.
4. Choose the length of the chain you need, then weave the
fixture wire and the fixture grounding wire through the chain.
Then connect one end of the chain with the hook by using
the loop lock.
5. Secure the top loop to nipple(-a).
6. Thread the fixture wire and fixture grounding wire through
the collar, canopy, top loop, nipple(-a) and mounting strap.
7. Connect the other end of the chain with the top loop by
using the loop lock.
8. Pull out the outlet wires and the house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black
wire from the power source.
---The ridged wire (unmarked) from the fixture to the white
wire from the power source.
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the
house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting strap by inserting the top
loop, then secure it with the collar.
10. Attach the glass shades onto the glass holders, then secure
them with the socket rings, using supplied socket ring fixer.
11. Install bulbs(not included). See relamping label at socket
area or packaging for maximum allowed wattage.
12. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
CP-CHU003 / CHU006
070119