Installation Guide

Fixture Wire
Chain
Mounting Screw
Nipple(-a)
Fixture Grounding Wire
Collar
Top Loop
Canopy
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Outlet Box
House Grounding Wire
Loop Lock
Loop Lock
070508
1. Attach nipple(-a) to the mounting strap, then secure it
with a washer and hex nut.
2. Attach the mounting strap to the outlet box by using
two mounting screws.
3. Secure the top loop to nipple(-a).
4. Secure the coupling assembly onto nipple(-b) of main
fixture. Attach the assembly set onto the main fixture in
turn by inserting the nipple of the coupling set, then
secure them with loop.
5. Attach the column upward to the center socket of the main
fixture, then secure it with a socket ring.
6. Choose the length of the chain you need, then weave
the fixture wire and the fixture grounding wire through
the chain, collar and canopy.
7. Connect one end of the chain with the loop by using a
loop lock.
8. Connect the other end of the chain with the top loop by
using another loop lock.
9. Thread the fixture wire and fixture grounding wire through
the top loop, nipple(-a) and mounting strap.
10. Pull out the outlet wires and house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The smooth wire (marked) from the fixture to the black
wire from the power source.
---The ridged wire (unmarked) from the fixture to the white
wire from the power source.
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the
house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
11. Attach the canopy to the mounting strap by inserting the
top loop, then secure it with the collar.
12. Attach the glass shades to the glass holders, then
secure them with the socket rings.
13. Install bulbs (not included). See relamping label at
socket area or packaging for maximum allowed
wattage.
14. Turn on the power at the main fuse or circuit breaker
box. Use the 3-Way switch to control the light.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
CH30306
Loop
Assembly Set
Coupling Assembly
Nipple(-b)
3-Way Switch
Main Fixture
Socket Ring
Glass Holder
Center Socket
Column
Glass Shade
Socket Ring