Installation Guide

1. Unscrew the set screws and bolt nuts to separate the frame from the fixture.
2. Thread two screws through the cross bar, then secure them with two lock nuts. Adjust the
length of the screw if necessary.
3. Attach the cross bar to the outlet box by using two mounting screws.
4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire
connections using the wire nuts:
---The black wires from the light to the black wire from the power source.
---The white wires from the light to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw.
Then connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
5. Attach the fixture to the cross bar by inserting the screws, then secure it with two ball nuts.
6. Gently pull the clips upright to place the flat glasses into the frame, and then press them
back to secure the flat glasses. (See Fig.1 & Fig.2)
Note: The flat glass should be fastened into position as shown in Fig.3.
7. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
8. Restore the frame back to the fixture.
9. Turn on the power at the main fuse or circuit breaker box.
Mounting Screw
Fixture Wire
Back Plate
Set Screw
Socket
Bolt Nut
Frame
Fixture
Ball Nut
Lock Nut
Cross Bar
House Grounding Wire
Green Grounding Screw
Fixture Grounding Wire
Wire Nut
Screw
Outlet Box
070918
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
OW37273 / OW37293 / OW14673 / OW14693
Clip
Flat Glass
Clip
Frame
Pull the clip upright
Frame
Flat Glass
Clip
Clip
Fig.2 Fig.3Fig.1