Installation Guide

1. Attach two headless screws through the cross bar, then secure them with
four lock nuts (two on each side of the cross bar). Adjust the length of the
headless screws if necessary.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---The black wire from the light to the black wire from the power source.
---The white wire from the light to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
4. Attach the back plate to the cross bar by inserting the headless screws, then
secure it with the bolt nuts.
5. Install a bulb (not included). See relamping label at socket area or packaging
for maximum allowed wattage.
6. Turn on the power at the main fuse or circuit breaker box.
Bolt Nut
Back Plate
Fixture
Mounting Screw
Headless Screw
Fixture Wire
Lock Nut
Cross Bar
House Grounding Wire
Green Grounding Screw
Fixture Grounding Wire
Wire Nut
Outlet Box
060313
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
OW3013/OW3063