Installation Guide

1. Attach two screws through the cross bar, then secure them with two lock nuts.
Adjust the length of the screws if necessary.
2. Attach the cross bar to the wall box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---The black wire from the light to the black wire from the power source.
---The white wire from the light to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the wall box.
4. Attach the back plate to the cross bar by inserting the screws, then secure it
with the bolt nuts.
5. Attach the frame onto the fixture, then secure it with the socket ring.
6. Install a bulb (not included). See relamping label at socket area or packaging
for maximum allowed wattage.
7. Turn on the power at the main fuse or circuit breaker box.
Fixture
Frame
Socket Ring
Bolt Nut
Back Plate
Mounting Screw
Screw
Fixture Wire
Lock Nut
Cross Bar
House Grounding Wire
Green Grounding Screw
Wire Nut
Wall box
Fixture Grounding Wire
060116
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
OW37263