Installation Guide

1. Thread two headless screws to the cross bar, then secure them with four lock
nuts (two on each side of the cross bar). Adjust the length of the headless screws
if necessary.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire
connections using the wire nuts:
---The black wire from the light to the black wire from the power source.
---The white wire from the light to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully tuck the wires back into the outlet box.
4. Attach the fixture to the cross bar by inserting the headless screws, then secure it
with bolt nuts.
5. Install a bulb (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
6. Turn on the power at the main fuse or circuit breaker box.
Mounting Screw
Fixture Wire
Bolt Nut
Fixture
Lock Nut
Cross Bar
Fixture Grounding Wire
House Grounding Wire
Green Grounding Screw
Wire Nut
Headless Screw
Outlet Box
050622
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.
OW39783