Installation Guide

080124
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
OW50573 / OW50593 / OW50513
1. Thread two headless screws to the mounting plate, and secure them with four lock nuts (two on
each side of the mounting plate). Adjust the length of the headless screws if necessary.
Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will
be level.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Line up the holes in the frame to the set screws of the fixture, secure the frame onto the fixture
using bolt nuts.
4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
5. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with
two bolt nuts.
CAUTION: With silicone caulking compound, caulk completely around where the back
plate meets with the wall surface to prevent water from seeping into the outlet box.
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
7. Turn on the power at the main fuse or circuit breaker box.
House Grounding Wire
Green Grounding Screw
Fixture Grounding Wire
Wire Nut
Mounting Screw
Headless Screw
Mounting Plate
Outlet Box
Fixture Wire
Lock Nut
Back Plate
Bolt Nut
Fixture
Set Screw
Socket
Frame
Bolt Nut